Changeable Bead Rings Faqs:
When placing a bead on the post of the ring, make sure there is not a lot of space in between the bead and ToppeR ie: less than 0.5mm and that the bead is not too loose. Make sure the bead spins freely when you move it by hand but not so that it just turns freely on its own. IF there is resistance when you move the bead, then eventually the ToppeR will unscrew and you could lose the bead and ToppeR. You can also use a pair of pliers to grip the ToppeR after it has been hand tightened, turn ToppeR 1/4 turn to secure. The small rubber O-ring can be used to set between to disk shaped beads or to fill a small space below your bead to insure a good fit on the post.